How to Fix Guitar Pickup Damaged

Pick Up guitar is dead or damaged whether it is pickup type humbucker or single coil is often experienced by electric guitar users. And pick up or there is a mention of Spool is the most important component in electric guitar, without this component electric guitar will not sound.

  Actually to fix Pick Up broken guitar is not too difficult, you also do not have to be great in the field of electronics, the following zonagitar.net give a little tutorial to overcome Pickup Guitar Damaged or dead.


 What are the ingredients you need to prepare?

  1. Coils or reels
     ''There's a bunch of coils or rolls that are sold in electronics stores so it's pretty easy for us to get, But it's best to use small rolls, the smaller the better''
2. Plaster
3. Solder and Lead
4. Scales

If all the necessary materials and tools have been prepared then we go directly to the assembly process.

1, Please unload your guitar.
    ''Open the protector that is behind the body. Make sure it is sucked first, Make sure that your Pick Up is really damaged, you can use Avometer to find out How to Connect both ends of immune that is on Pick Up to Avometer if no movement of the needle, meaning your Pickup really has been damaged, But if otherwise should not continue to the next stage.''
Just in case you should take the first picture, because do not get, you forget the cable connection with other components.

2. Unload Pick Up remove the whole of the existing coil.
     Replace using the new Pick Up by scrolling it manually, do not roll in a hurry, because if it is cut off in the middle of the road, then you have to repeat it from scratch again, so you should do it slowly

3. Roll to full and solid, the more solid the better the sound you get.
     If you use Pickup Hambucker should do the rolling process, Try from both Pickup attached have same weight, you can use scales to measure it.
   
4. Once the rolling process has been done, it's time we connect both sides of the pickup by putting the end of the first Pick Up pickup with Second Pickup Edge by using Solder.
  
5. Take Isolation, Then swirl the pickup side point to protect the Pick Up that has been in glize earlier,
  
6 Replace the pickup on the body guitar.

Thank you for reading, hopefully useful for you, do not forget to comment, share, and follow. And also do not forget to visit again. Source zonagitar